FATO TÉRMICO HALO 3D
TKVT0301H3DLFE

FATO TÉRMICO HALO 3D

483,30 €
-10%

  • Preço reduzido
  • Guarda 10%
TKVT0301H3DLFE

FATO TÉRMICO HALO 3D

Consulta especialista
537,00 €
483,30 € (- 10%)
Com IVA
TAMANHO
Quantidade
Plazo de entrega estimado do fornecedor 15 días úteis.

¿Quieres pagar en 6 meses sin intereses ni gastos de formalización?
*Elige Financiación sin intereses al realizar tu pago.
Description:

Maximising thermal protection whilst minimising buoyancy, the HALO 3D has body mapped insulation, strategically placed to enhance protection when in horizontal trim. Designed for use underneath membrane and trilaminate suits, the HALO 3D is the perfect complement to our current range of drysuit thermal protection. In a layering combination with Xerotherm, HALO 3D is suitable for the harshest diving conditions on the planet.

Halo 3D Features:

SpaceTek Compression Resistant Panels: SPACETEK material blends perfectly with the dual layer construction to provide a constant, compression resistant layer of air on the torso front, thighs and shoulders. The benefit of this additional protection becomes clear, as soon as you enter the water as you feel cocooned by 8mm thick enhanced thermal protection layers.



High Density Fleece: Three layers of heavyweight, high density material enhance protection of critical areas. The back, kidney region, buttocks and hamstring region are protected. Combined with the insulation offered by the SPACETEK material, you will feel warmer and better protected.



One Piece Design: The one piece design is simple and functional; lower profile around the hips and midriff, allowing high manoeuvrability with panels of additional thermal protection layers located where they are needed most, enhancing the thermal protection in critical zones without excessive bulkiness. It can be worn as part of a layer system with drybase, xerotherm and in extreme cases, even Arctic.



Thumb Loops on the sleeves make donning a drysuit on top of the Halo 3D easy. There is a useful pocket in the right arm is ideal for small valuables. P-valve holes are located at the inner thigh on both legs so the user can select the preferred leg for routing the catheter, the holes are not fully open as only a small number of users will need to use them. If a p-valve is required you will need to carefully cut using sharp scissors to open the hole wide enough for the catheter tube to fit through. Be careful not to cut into or beyond the end of the button hole stitching as this will allow the fabric to fray.
Producto fuera de stock. Consultar en los próximos: 15.0000000000 días de entrega

Ficha informativa

FATOS
ROUPA INTERIOR
MODELO
MONO
PRESTAÇÕES
FECHO NOS TORNOZELOS
PRESTAÇÕES
FECHO FRONTAL PESCOÇO
ESPESSURA
Menor que 3MM
GÉNERO
MULHER
GÉNERO
HOMEM